online memory for 3d printing, linux, raspberry pi and other fun projects.
With the shortage of Raspberry Pi’s still going on I picked up a BTT Pi 1.2 instead to run Klipper for me on my 0.2 build. The initial install went smoothly and I was up and printing in no time however when I connected the ADXL cable everything went downhill until I found the proper […]
Since swapping from Marlin to Klipper and printing at a wall speed north of 100 MM/S I have begun to be bound by cooling. My “minimum layer time” I couldn’t get under 10 seconds without seeing issues on small models. This began quite the journey of printing up various cooling options and I think finally […]
My fastest PLA Cura profile yet. 140 mm/s speed on a mostly stock Ender 3 S1 using Marlin. No need for Klipper. If you have a well tuned printer this is the profile to try.